Although resin bonded surfaces require extremely low maintenance to make them look new, there are a few simple steps you can take at home to keep the surface in good condition.
IMMEDIATE CONSEQUENCES ON YOUR RESIN SURFACE
Nothing must touch the resin (until it hardens) which can cause fingerprints. Cats and foxes will be the main culprits, so it’s important to surround the area as much as possible and be careful with animals in the area.
GENERAL CLEANING
To remove leaves, sand, dirt, and other similar materials from your floor, simply clean with a stiff brush. Cleaning the resin surface can be resin driveway DIY with clean water will also clean the floor. Regularly brushing and draining pipes is the most common source of maintenance on resin-bonded surfaces.
If they are not cleaned and remain on the resin surface for a long time, spots of debris may appear. The most difficult stains and dirty objects can be removed with a high-pressure machine (maximum value 150 bar). A jet lance should be used and sprayed at least 200mm above the resin surface. Only cold water should be used to apply the resin.
If a gum adheres to the resin surface, it can be easily removed with a coolant spray. Each piece of gum should be hardened with a freezer spray, then gently scraped off with a suitable scraper.
WEED REMOVAL
The resin surface treatment is weed resistant and is treated by growing the weeds before applying the resin. Weeds should not grow on the surface, but airborne seedlings can land on their surface and cause some growth. If you are using a strong herbicide, water it thoroughly. Strong herbicides that are not watered can discolor the resin driveway material surface.
FOAM REMOVAL
It is very unlikely that moss or algae will grow on your resin floor after resin driveway DIY, however, certain climates and weather conditions can mean that moss can grow. The moss and algae exterminator can be applied from time to time, according to the manufacturer’s instructions. This will remove and prevent the foam from coming back.
BRAKE FLUID
Brake fluid is extremely corrosive to resin-bonded surfaces. If the brake fluid spills on the road, remove it immediately with lukewarm water.
ENGINE FLUID / OIL / FUEL
Engine fluid can cause stains on resin surfaces, so it is important to prevent engine fluid from spilling onto the surface with a mild detergent, such as windshield wipers and car shampoo mixed with it. hot water from the car. To remove fuel and oil stains, use a stiff brush to apply the emulsifier. Soak the detergent for 10 minutes, then use a pressure washer to remove it from the surface.
TIRE BRANDS
To prevent tire tracks from appearing on the surface, try not to turn the steering wheel when it is stopped. If there are traces of rubber on the surface, it is enough to clean them with turpentine and wash them with an emulsifier and high-pressure apparatus.
ICE
While our resin driveway material bonded surface reduces the risk of ice and slippage, caution is advised. White rock salt can be used on resin surfaces to remove ice and ice. Be sure to remove any remaining salt when the weather has calmed down.
